Hi, On 03/04/2019 16:52:44+0200, Flavio Suligoi wrote: > Some RTC devices have a battery-low automatic detection circuit. > The battery-low event is usually reported with: > > - a bit change in a RTC status register > - a hw signaling (generally using an interrupt generation), changing > the hw level of a specific pin; > > The new property "battery-low-hw-alarm" enable the RTC to generate the > hw signaling in case of battery-low event. > > Signed-off-by: Flavio Suligoi <f.suli...@asem.it> > --- > Documentation/devicetree/bindings/rtc/rtc.txt | 3 +++ > 1 file changed, 3 insertions(+) > > diff --git a/Documentation/devicetree/bindings/rtc/rtc.txt > b/Documentation/devicetree/bindings/rtc/rtc.txt > index a97fc6a..f93a44d 100644 > --- a/Documentation/devicetree/bindings/rtc/rtc.txt > +++ b/Documentation/devicetree/bindings/rtc/rtc.txt > @@ -31,6 +31,9 @@ below. > expressed in femto Farad (fF). > The default value shall be listed (if optional), > and likewise all valid values. > +- battery-low-hw-alarm : Enable the "battery-low" output pin. This > function
I would name that voltage-low-alarm as not all the secondary voltages are batteries. > + is available on the following devices: > + - pcf2127 - pin used for alarm: INTn > > Trivial RTCs > ------------ > -- > 2.7.4 > -- Alexandre Belloni, Bootlin Embedded Linux and Kernel engineering https://bootlin.com
