From: Shubhrajyoti Datta <[email protected]> Change logic how console_port is setup by using CON_ENABLED flag instead of index. There will be unique uart_console structure that's why code can't use id for console_port assignment.
Signed-off-by: Shubhrajyoti Datta <[email protected]> Signed-off-by: Michal Simek <[email protected]> --- drivers/tty/serial/uartlite.c | 10 ++++++++-- 1 file changed, 8 insertions(+), 2 deletions(-) diff --git a/drivers/tty/serial/uartlite.c b/drivers/tty/serial/uartlite.c index 4a7989d..9c99a1d9 100644 --- a/drivers/tty/serial/uartlite.c +++ b/drivers/tty/serial/uartlite.c @@ -665,7 +665,7 @@ static int ulite_assign(struct device *dev, int id, u32 base, int irq, * If register_console() don't assign value, then console_port pointer * is cleanup. */ - if (ulite_uart_driver.cons->index == -1) + if (!console_port) console_port = port; #endif @@ -680,7 +680,8 @@ static int ulite_assign(struct device *dev, int id, u32 base, int irq, #ifdef CONFIG_SERIAL_UARTLITE_CONSOLE /* This is not port which is used for console that's why clean it up */ - if (ulite_uart_driver.cons->index == -1) + if (console_port == port && + !(ulite_uart_driver->cons->flags & CON_ENABLED)) console_port = NULL; #endif @@ -859,6 +860,11 @@ static int ulite_remove(struct platform_device *pdev) clk_unprepare(pdata->clk); rc = ulite_release(&pdev->dev); +#ifdef CONFIG_SERIAL_UARTLITE_CONSOLE + if (console_port == port) + console_port = NULL; +#endif + pm_runtime_disable(&pdev->dev); pm_runtime_set_suspended(&pdev->dev); pm_runtime_dont_use_autosuspend(&pdev->dev); -- 2.1.1
