[PATCH 04/15] fsi/fsi-master-gpio: Sample input data on different clock phase

[Benjamin Herrenschmidt]

We currently sample the input data right after we toggle the
clock low, then high. The slave establishes the data on the
rising edge, so this is not ideal. We should sample it on
the low phase instead.

This currently works because we have an extra delay, but subsequent
patches will remove it.

Signed-off-by: Benjamin Herrenschmidt <b...@kernel.crashing.org>
Reviewed-by: Christopher Bostic <cbos...@linux.vnet.ibm.com>
---
 drivers/fsi/fsi-master-gpio.c | 8 +++++---
 1 file changed, 5 insertions(+), 3 deletions(-)

diff --git a/drivers/fsi/fsi-master-gpio.c b/drivers/fsi/fsi-master-gpio.c
index 4295a46780cb..d6508bbad1fb 100644
--- a/drivers/fsi/fsi-master-gpio.c
+++ b/drivers/fsi/fsi-master-gpio.c
@@ -86,12 +86,15 @@ static void clock_toggle(struct fsi_master_gpio *master, 
int count)
        }
 }
 
-static int sda_in(struct fsi_master_gpio *master)
+static int sda_clock_in(struct fsi_master_gpio *master)
 {
        int in;
 
        ndelay(FSI_GPIO_STD_DLY);
+       gpiod_set_value(master->gpio_clk, 0);
        in = gpiod_get_value(master->gpio_data);
+       ndelay(FSI_GPIO_STD_DLY);
+       gpiod_set_value(master->gpio_clk, 1);
        return in ? 1 : 0;
 }
 
@@ -126,8 +129,7 @@ static void serial_in(struct fsi_master_gpio *master, 
struct fsi_gpio_msg *msg,
        set_sda_input(master);
 
        for (bit = 0; bit < num_bits; bit++) {
-               clock_toggle(master, 1);
-               in_bit = sda_in(master);
+               in_bit = sda_clock_in(master);
                msg->msg <<= 1;
                msg->msg |= ~in_bit & 0x1;      /* Data is active low */
        }
-- 
2.17.0