Some interrupts properties are given '0' as the flags argument or no
flags argument at all.
Change them to use the appropriate interrupt flags.
Signed-off-by: Lothar Waßmann <l...@karo-electronics.de>
---
arch/arm/boot/dts/imx53-tx53-x03x.dts | 2 +-
arch/arm/boot/dts/imx53-tx53.dtsi | 4 ++--
2 files changed, 3 insertions(+), 3 deletions(-)
diff --git a/arch/arm/boot/dts/imx53-tx53-x03x.dts
b/arch/arm/boot/dts/imx53-tx53-x03x.dts
index aa9ae84..eb5b452 100644
--- a/arch/arm/boot/dts/imx53-tx53-x03x.dts
+++ b/arch/arm/boot/dts/imx53-tx53-x03x.dts
@@ -254,7 +254,7 @@
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_tsc2007>;
interrupt-parent = <&gpio3>;
- interrupts = <26 0>;
+ interrupts = <26 IRQ_TYPE_EDGE_FALLING>;
gpios = <&gpio3 26 GPIO_ACTIVE_LOW>;
ti,x-plate-ohms = <660>;
wakeup-source;
diff --git a/arch/arm/boot/dts/imx53-tx53.dtsi
b/arch/arm/boot/dts/imx53-tx53.dtsi
index 8e10c47..71b58b6 100644
--- a/arch/arm/boot/dts/imx53-tx53.dtsi
+++ b/arch/arm/boot/dts/imx53-tx53.dtsi
@@ -227,7 +227,7 @@
phy0: ethernet-phy@0 {
interrupt-parent = <&gpio2>;
- interrupts = <4>;
+ interrupts = <4 IRQ_TYPE_EDGE_FALLING>;
device_type = "ethernet-phy";
};
};
@@ -247,7 +247,7 @@
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_ds1339>;
interrupt-parent = <&gpio4>;
- interrupts = <20 0>;
+ interrupts = <20 IRQ_TYPE_EDGE_FALLING>;
trickle-resistor-ohms = <250>;
trickle-diode-disable;
};
--
2.1.4
