Use the 'interrupts-extended' property instead of pairs of
'interrupt-parent', 'interrupts' properties.
Signed-off-by: Lothar Waßmann <l...@karo-electronics.de>
---
arch/arm/boot/dts/imx6ul-tx6ul.dtsi | 12 ++++--------
1 file changed, 4 insertions(+), 8 deletions(-)
diff --git a/arch/arm/boot/dts/imx6ul-tx6ul.dtsi
b/arch/arm/boot/dts/imx6ul-tx6ul.dtsi
index f8f7685..97c7047 100644
--- a/arch/arm/boot/dts/imx6ul-tx6ul.dtsi
+++ b/arch/arm/boot/dts/imx6ul-tx6ul.dtsi
@@ -325,8 +325,7 @@
reg = <0>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_etnphy0_int>;
- interrupt-parent = <&gpio5>;
- interrupts = <5 IRQ_TYPE_EDGE_FALLING>;
+ interrupts-extended = <&gpio5 5 IRQ_TYPE_EDGE_FALLING>;
status = "okay";
};
@@ -335,8 +334,7 @@
reg = <2>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_etnphy1_int>;
- interrupt-parent = <&gpio4>;
- interrupts = <27 IRQ_TYPE_EDGE_FALLING>;
+ interrupts-extended = <&gpio4 27 IRQ_TYPE_EDGE_FALLING>;
status = "okay";
};
};
@@ -383,8 +381,7 @@
reg = <0x38>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_edt_ft5x06>;
- interrupt-parent = <&gpio5>;
- interrupts = <2 IRQ_TYPE_EDGE_FALLING>;
+ interrupts-extended = <&gpio5 2 IRQ_TYPE_EDGE_FALLING>;
reset-gpios = <&gpio5 3 GPIO_ACTIVE_LOW>;
wake-gpios = <&gpio5 8 GPIO_ACTIVE_HIGH>;
wakeup-source;
@@ -395,8 +392,7 @@
reg = <0x48>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_tsc2007>;
- interrupt-parent = <&gpio3>;
- interrupts = <26 IRQ_TYPE_NONE>;
+ interrupts-extended = <&gpio3 26 IRQ_TYPE_NONE>;
gpios = <&gpio3 26 GPIO_ACTIVE_LOW>;
ti,x-plate-ohms = <660>;
wakeup-source;
--
2.1.4
