On Mon, 9 Oct 2017 12:20:35 -0400 Steven Rostedt <rost...@goodmis.org> wrote:
> > > SAVE_REGS_IF_SUPPORTED - Similar to SAVE_REGS but the registering of a > > > ftrace_ops on an architecture that does not support passing of regs > > > will not fail with this flag set. But the callback must check if > > > regs is NULL or not to determine if the architecture supports it. > > > > > > RECURSION_SAFE - By default, a wrapper is added around the callback to > > > make sure that recursion of the function does not occur. That is > > > if a function within the callback itself is also traced, ftrace > > > > s/within the/called by the/ > > I put in "within" because it is usually a function that is nested > within a function called by the callback. This bug has come up with > "gotchas", where some function that the callback calls has a path to a > function that was unexpectedly traced. > > The issue hasn't been caused by a function being traced that was > directly called by the callback. It is usually some deeper nested > function. > > I don't want to limit it to just checking functions that the callback > calls. Thoughts on how to stress this? "if a function that is called as a result of the callback's execution is also traced" ? > > > IPMODIFY - Requires SAVE_REGS set. If the callback is to "hijack" the > > > traced function (have another function called instead of the traced > > > function), it requires setting this flag. This is what live kernel > > > patches uses. Without this flag the pt_regs->ip can not be modified. > > > Note, only one ftrace_ops with IPMODIFY set may be registered to > > > any given function at a time. > > > > I assume this requires being able to get the regs too? > > Yes, this is why I stated "Requires SAVE_REGS" which would pass the > regs to the callback. Should I rewrite that somehow? No, just ship me another cup of coffee and that one should be OK. Though perhaps if you'd spelled out the flag completely I wouldn't have been so dense :) > > > If a glob is used to set the filter, to remove unwanted matches the > > > ftrace_set_notrace() can also be used. > > > > > > int ftrace_set_notrace(struct ftrace_ops *ops, unsigned char *buf, > > > int len, int reset); > > > > > > This takes the same parameters as ftrace_set_filter() but will add the > > > functions it finds to not be traced. This doesn't remove them from the > > > filter itself, but keeps them from being traced. If @reset is set, > > > the filter is cleaded but the functions that match @buf will still not > > > > cleaded? :) > > Hmm, I'll have to be more descriptive. > > > > > > be traced (the callback will not be called on those functions). > > > > So how do you clead the "notrace" list? > > With passing in reset non-zero. I'll add that. My confusion remains here. The text says that if reset is "set", then the "notrace" list remains in place. So a non-zero "reset" value will remove previous notrace entries, along with the filter itself? So if you wanted to clear the notrace list entirely you would use buf="", reset=1? It would be good to be explicit there. Thanks, jon
