The original patch from Tony uses standby mode bit inverted, which is
not correct. This fixes all instances in the driver code for get & set
mode. This did not yet make problems, since mode has not been changed
by any mainline driver so far.
Fixes: 0ad4c07edd41 ("regulator: cpcap: Add basic regulator support")
Acked-by: Tony Lindgren <t...@atomide.com>
Signed-off-by: Sebastian Reichel <sebastian.reic...@collabora.co.uk>
---
drivers/regulator/cpcap-regulator.c | 8 +++++---
1 file changed, 5 insertions(+), 3 deletions(-)
diff --git a/drivers/regulator/cpcap-regulator.c
b/drivers/regulator/cpcap-regulator.c
index cc98aceed1c1..ce1cab320f6f 100644
--- a/drivers/regulator/cpcap-regulator.c
+++ b/drivers/regulator/cpcap-regulator.c
@@ -77,6 +77,8 @@
#define CPCAP_BIT_VAUDIO_MODE0 BIT(1)
#define CPCAP_BIT_V_AUDIO_EN BIT(0)
+#define CPCAP_BIT_AUDIO_NORMAL_MODE 0x00
+
/*
* Off mode configuration bit. Used currently only by SW5 on omap4. There's
* the following comment in Motorola Linux kernel tree for it:
@@ -217,7 +219,7 @@ static unsigned int cpcap_regulator_get_mode(struct
regulator_dev *rdev)
regmap_read(rdev->regmap, rdev->desc->enable_reg, &value);
- if (!(value & CPCAP_BIT_AUDIO_LOW_PWR))
+ if (value & CPCAP_BIT_AUDIO_LOW_PWR)
return REGULATOR_MODE_STANDBY;
return REGULATOR_MODE_NORMAL;
@@ -230,10 +232,10 @@ static int cpcap_regulator_set_mode(struct regulator_dev
*rdev,
switch (mode) {
case REGULATOR_MODE_NORMAL:
- value = CPCAP_BIT_AUDIO_LOW_PWR;
+ value = CPCAP_BIT_AUDIO_NORMAL_MODE;
break;
case REGULATOR_MODE_STANDBY:
- value = 0;
+ value = CPCAP_BIT_AUDIO_LOW_PWR;
break;
default:
return -EINVAL;
--
2.13.2
