On Wed, Jan 18, 2017 at 04:38:16PM -0600, Rob Herring wrote:
> On Fri, Jan 13, 2017 at 01:05:52PM -0200, Sergio Prado wrote:
> > +This file documents differences between the core mmc properties described
> > by
> > +mmc.txt and the properties used by the Samsung S3C24XX MMC/SD/SDIO
> > controller
> > +implementation.
> > +
> > +Required SoC Specific Properties:
> > +- compatible: should be one of the following
> > + - "samsung,s3c2410-sdi": for controllers compatible with s3c2410
> > + - "samsung,s3c2412-sdi": for controllers compatible with s3c2412
> > + - "samsung,s3c2440-sdi": for controllers compatible with s3c2440
> > +- clocks: Should reference the controller clock
> > +- clock-names: Should contain "sdi"
>
> You are missing things from the example.
Properties "compatible", "clocks" and "clock-names" are documented.
Properties "bus-width", "cd-gpios" and "wp-gpios" are documented in
mmc.txt as I described before the example. Should I describe them again?
Do I need to document common properties like "pinctrl-names",
"pinctrl-0", "reg" and "interrupts"?
>
> > +
> > +Example:
> > + mmc0: mmc@5a000000 {
> > + compatible = "samsung,s3c2440-sdi";
> > + pinctrl-names = "default";
> > + pinctrl-0 = <&sdi_pins>;
> > + reg = <0x5a000000 0x100000>;
> > + interrupts = <0 0 21 3>;
> > + clocks = <&clocks PCLK_SDI>;
> > + clock-names = "sdi";
> > + bus-width = <4>;
> > + cd-gpios = <&gpg 8 GPIO_ACTIVE_LOW>;
> > + wp-gpios = <&gph 8 GPIO_ACTIVE_LOW>;
> > + };
> > +
> > + Note: This example shows both SoC specific and board specific properties
> > + in a single device node. The properties can be actually be separated
> > + into SoC specific node and board specific node.
>
> The source structure is not relavent to the binding.
OK.
>
> Rob
--
Sergio Prado
Embedded Labworks
Office: +55 11 2628-3461
Mobile: +55 11 97123-3420
