On Sun, Jan 15, 2017 at 12:13:07PM +0100, Nicholas Mc Guire wrote: > ulseep_range() uses hrtimers and provides no advantage over msleep() > for larger delays. Fix up the 50ms delays here to use msleep() and > reduce the load on the hrtimer subsystem. > > Signed-off-by: Nicholas Mc Guire <hof...@osadl.org>
Applied, thank you. > --- > Problem found by coccinelle script > > As the needed delay is specified in the comment as being "at least 50ms" > the msleep(50) should be fine here. > > Note that cyapa_gen3_bl_exit() is returning -EAGAIN in cases where it was > not yet ready to process the request, but the calling side > cyapa_gen3_do_operational_check() does not check for -EAGAIN so in case of > the noted increased delay "...can take up to an additional 2 seconds. If > the device power is running low, this may take even longer", maybe > cyapa_gen3_do_operational_check() may need a retry loop on -EAGAIN ? > > Patch was compile tested with: x86_64_defconfig + CONFIG_MOUSE_CYAPA=m > > Patch is against 4.10-rc3 (localversion-next is next-20170113) > > drivers/input/mouse/cyapa_gen3.c | 2 +- > 1 file changed, 1 insertion(+), 1 deletion(-) > > diff --git a/drivers/input/mouse/cyapa_gen3.c > b/drivers/input/mouse/cyapa_gen3.c > index f9600753..6e9ecb0 100644 > --- a/drivers/input/mouse/cyapa_gen3.c > +++ b/drivers/input/mouse/cyapa_gen3.c > @@ -562,7 +562,7 @@ static int cyapa_gen3_bl_exit(struct cyapa *cyapa) > * Wait for bootloader to exit, and operation mode to start. > * Normally, this takes at least 50 ms. > */ > - usleep_range(50000, 100000); > + msleep(50); > /* > * In addition, when a device boots for the first time after being > * updated to new firmware, it must first calibrate its sensors, which > -- > 2.1.4 > -- Dmitry
