Currently we handle both old style GPIO and new style GPIOD differently
simplify this slightly by converting the old style GPIO to a GPIOD and
just using that from then on.
Signed-off-by: Charles Keepax <ckee...@opensource.wolfsonmicro.com>
---
drivers/extcon/extcon-arizona.c | 20 ++++++++------------
1 file changed, 8 insertions(+), 12 deletions(-)
diff --git a/drivers/extcon/extcon-arizona.c b/drivers/extcon/extcon-arizona.c
index 56e6c4c..aeab47d 100644
--- a/drivers/extcon/extcon-arizona.c
+++ b/drivers/extcon/extcon-arizona.c
@@ -236,12 +236,8 @@ static void arizona_extcon_set_mode(struct
arizona_extcon_info *info, int mode)
mode %= info->micd_num_modes;
- if (arizona->pdata.micd_pol_gpio > 0)
- gpio_set_value_cansleep(arizona->pdata.micd_pol_gpio,
- info->micd_modes[mode].gpio);
- else
- gpiod_set_value_cansleep(info->micd_pol_gpio,
- info->micd_modes[mode].gpio);
+ gpiod_set_value_cansleep(info->micd_pol_gpio,
+ info->micd_modes[mode].gpio);
regmap_update_bits(arizona->regmap, ARIZONA_MIC_DETECT_1,
ARIZONA_MICD_BIAS_SRC_MASK,
@@ -1410,21 +1406,21 @@ static int arizona_extcon_probe(struct platform_device
*pdev)
regmap_update_bits(arizona->regmap, ARIZONA_GP_SWITCH_1,
ARIZONA_SW1_MODE_MASK, arizona->pdata.gpsw);
- if (arizona->pdata.micd_pol_gpio > 0) {
+ if (pdata->micd_pol_gpio > 0) {
if (info->micd_modes[0].gpio)
mode = GPIOF_OUT_INIT_HIGH;
else
mode = GPIOF_OUT_INIT_LOW;
- ret = devm_gpio_request_one(&pdev->dev,
- arizona->pdata.micd_pol_gpio,
- mode,
- "MICD polarity");
+ ret = devm_gpio_request_one(&pdev->dev, pdata->micd_pol_gpio,
+ mode, "MICD polarity");
if (ret != 0) {
dev_err(arizona->dev, "Failed to request GPIO%d: %d\n",
- arizona->pdata.micd_pol_gpio, ret);
+ pdata->micd_pol_gpio, ret);
goto err_register;
}
+
+ info->micd_pol_gpio = gpio_to_desc(pdata->micd_pol_gpio);
} else {
if (info->micd_modes[0].gpio)
mode = GPIOD_OUT_HIGH;
--
2.1.4
