On 11/09/2016 05:35 AM, Masahiro Yamada wrote:
> Such debug lines might be useful when debugging the driver first,
> but should be deleted from the upstream code.
>
> Signed-off-by: Masahiro Yamada <yamada.masah...@socionext.com>
Reviewed-by: Marek Vasut <marek.va...@gmail.com>
> ---
>
> drivers/mtd/nand/denali.c | 12 ------------
> 1 file changed, 12 deletions(-)
>
> diff --git a/drivers/mtd/nand/denali.c b/drivers/mtd/nand/denali.c
> index 14e66ab..e32e13c 100644
> --- a/drivers/mtd/nand/denali.c
> +++ b/drivers/mtd/nand/denali.c
> @@ -181,9 +181,6 @@ static uint16_t denali_nand_reset(struct denali_nand_info
> *denali)
> {
> int i;
>
> - dev_dbg(denali->dev, "%s, Line %d, Function: %s\n",
> - __FILE__, __LINE__, __func__);
> -
> for (i = 0; i < denali->max_banks; i++)
> iowrite32(INTR_STATUS__RST_COMP | INTR_STATUS__TIME_OUT,
> denali->flash_reg + INTR_STATUS(i));
> @@ -233,9 +230,6 @@ static void nand_onfi_timing_set(struct denali_nand_info
> *denali,
> uint16_t acc_clks;
> uint16_t addr_2_data, re_2_we, re_2_re, we_2_re, cs_cnt;
>
> - dev_dbg(denali->dev, "%s, Line %d, Function: %s\n",
> - __FILE__, __LINE__, __func__);
> -
> en_lo = CEIL_DIV(Trp[mode], CLK_X);
> en_hi = CEIL_DIV(Treh[mode], CLK_X);
> #if ONFI_BLOOM_TIME
> @@ -480,9 +474,6 @@ static uint16_t denali_nand_timing_set(struct
> denali_nand_info *denali)
> uint8_t maf_id, device_id;
> int i;
>
> - dev_dbg(denali->dev, "%s, Line %d, Function: %s\n",
> - __FILE__, __LINE__, __func__);
> -
> /*
> * Use read id method to get device ID and other params.
> * For some NAND chips, controller can't report the correct
> @@ -537,9 +528,6 @@ static uint16_t denali_nand_timing_set(struct
> denali_nand_info *denali)
> static void denali_set_intr_modes(struct denali_nand_info *denali,
> uint16_t INT_ENABLE)
> {
> - dev_dbg(denali->dev, "%s, Line %d, Function: %s\n",
> - __FILE__, __LINE__, __func__);
> -
> if (INT_ENABLE)
> iowrite32(1, denali->flash_reg + GLOBAL_INT_ENABLE);
> else
>
--
Best regards,
Marek Vasut
