On Thu, 15 Feb 2007, Mockern wrote:

> I have a question about linux tty driver
>
> how to support cp, cat operations in tty driver (like tiny_tty)?
> (e.g. echo "hello tty" > /dev/ttyS3, cat < ttyS10 etc)
>
> There a lot of examples with char drivers, but I could not find it for tty 
> Linux driver.
>

It works out of the box. Just keep hardware flow-control turned off
if there are no receivers connected to the output port. Also, you need
to set up the port's baud-rate and (usually) to make it transparent to
control characters (man tc-get/set-attr).

Cheers,
Dick Johnson
Penguin : Linux version 2.6.16.24 on an i686 machine (5592.61 BogoMips).
New book: http://www.AbominableFirebug.com/
_


****************************************************************
The information transmitted in this message is confidential and may be 
privileged.  Any review, retransmission, dissemination, or other use of this 
information by persons or entities other than the intended recipient is 
prohibited.  If you are not the intended recipient, please notify Analogic 
Corporation immediately - by replying to this message or by sending an email to 
[EMAIL PROTECTED] - and destroy all copies of this information, including any 
attachments, without reading or disclosing them.

Thank you.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/

Reply via email to