On Sat, Jul 16, 2016 at 03:29:06PM +0100, Jamie Lentin wrote:
> If PHY is registered via. a DSA switch, the MDIO bus the phy is on does
> not exist in devicetree, but there may be a reference to the PHY node
> on the physical MDIO bus to use.
O.K, i see what you are trying to achieve, it makes sense, but sorry,
NACK.
There is however a nice solution :-)
If you look in net-next, you will notice a big change to DSA. There is
a new binding, and the mv88e6xxx driver now exports the switch
internal MDIO bus just like any other MDIO bus. So you can have a phy
on the MDIO bus, and that phy can have "marvell,reg-init" properties.
Andrew
>
> Signed-off-by: Jamie Lentin <j...@lentin.co.uk>
> ---
> drivers/net/phy/marvell.c | 22 ++++++++++++++++------
> 1 file changed, 16 insertions(+), 6 deletions(-)
>
> diff --git a/drivers/net/phy/marvell.c b/drivers/net/phy/marvell.c
> index 280e879..c2ca347 100644
> --- a/drivers/net/phy/marvell.c
> +++ b/drivers/net/phy/marvell.c
> @@ -302,14 +302,24 @@ static int marvell_config_aneg(struct phy_device
> *phydev)
> */
> static int marvell_of_reg_init(struct phy_device *phydev)
> {
> - const __be32 *paddr;
> + const __be32 *paddr = NULL;
> int len, i, saved_page, current_page, page_changed, ret;
> + struct device_node *phy_dn;
> +
> + if (phydev->mdio.dev.of_node)
> + paddr = of_get_property(phydev->mdio.dev.of_node,
> + "marvell,reg-init", &len);
> + else if (phydev->attached_dev->dev.of_node) {
> + /* A DSA slave-mii-bus has no OF node, but the PHY might */
> + phy_dn = of_parse_phandle(phydev->attached_dev->dev.of_node,
> + "phy-handle", 0);
> + if (phy_dn) {
> + paddr = of_get_property(phy_dn,
> + "marvell,reg-init", &len);
> + of_node_put(phy_dn);
> + }
> + }
>
> - if (!phydev->mdio.dev.of_node)
> - return 0;
> -
> - paddr = of_get_property(phydev->mdio.dev.of_node,
> - "marvell,reg-init", &len);
> if (!paddr || len < (4 * sizeof(*paddr)))
> return 0;
>
> --
> 2.8.1
>
