On 15.06.2016 21:41, Rob Herring wrote:
On Tue, Jun 14, 2016 at 11:31 PM, Sakari Ailus <sakari.ai...@iki.fi> wrote:
Hi Rob,
On Tue, Jun 14, 2016 at 05:05:17PM -0500, Rob Herring wrote:
On Sat, Jun 11, 2016 at 06:39:53PM +0300, Ivaylo Dimitrov wrote:
Add DT bindings description
Not exactly the best commit msg.
will elaborate a bit more in the next patch version
Signed-off-by: Ivaylo Dimitrov <ivo.g.dimitrov...@gmail.com>
---
.../bindings/media/i2c/toshiba,et8ek8.txt | 50 ++++++++++++++++++++++
1 file changed, 50 insertions(+)
create mode 100644
Documentation/devicetree/bindings/media/i2c/toshiba,et8ek8.txt
diff --git a/Documentation/devicetree/bindings/media/i2c/toshiba,et8ek8.txt
b/Documentation/devicetree/bindings/media/i2c/toshiba,et8ek8.txt
new file mode 100644
index 0000000..997d268
--- /dev/null
+++ b/Documentation/devicetree/bindings/media/i2c/toshiba,et8ek8.txt
@@ -0,0 +1,50 @@
+Toshiba et8ek8 5MP sensor
+
+Toshiba et8ek8 5MP sensor is an image sensor found in Nokia N900 device
+
+More detailed documentation can be found in
+Documentation/devicetree/bindings/media/video-interfaces.txt .
+
+
+Mandatory properties
+--------------------
+
+- compatible: "toshiba,et8ek8"
+- reg: I2C address (0x3e, or an alternative address)
+- vana-supply: Analogue voltage supply (VANA), 2.8 volts
+- clocks: External clock to the sensor
+- clock-frequency: Frequency of the external clock to the sensor
These should be mutually-exclusive. If you have a clock, then you can
get the frequency at runtime.
Yes, you can. But the intention is to set the frequency: the sensor requires
a particular, pre-determined frequency. Typically this is specific to the
board.
Okay, then state that in the description.
ok, will do in the next patch version
Thanks,
Ivo
