On Fri, May 13, 2016 at 8:03 PM, Grygorii Strashko
<grygorii.stras...@ti.com> wrote:
> The PM runtime will be left disabled for the device if its .suspend_late()
> callback fails and async suspend is not allowed for this device. In
> this case device will not be added in dpm_late_early_list and
> dpm_resume_early() will ignore this device, as result PM runtime will
> be disabled for it forever (side effect: after 8 subsequent failures
> for the same device the PM runtime will be reenabled due to
> disable_depth overflow).
>
> Hence, re-enable PM runtime in __device_suspend_late() if
> .suspend_late() callback fails and async suspend is not allowed for
> this device.
>
> Signed-off-by: Grygorii Strashko <grygorii.stras...@ti.com>
> ---
> drivers/base/power/main.c | 7 +++++--
> 1 file changed, 5 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/base/power/main.c b/drivers/base/power/main.c
> index 6e7c3cc..9b266e5 100644
> --- a/drivers/base/power/main.c
> +++ b/drivers/base/power/main.c
> @@ -1207,10 +1207,13 @@ static int __device_suspend_late(struct device *dev,
> pm_message_t state, bool as
> }
>
> error = dpm_run_callback(callback, dev, state, info);
> - if (!error)
> + if (!error) {
> dev->power.is_late_suspended = true;
> - else
> + } else {
> async_error = error;
> + if (!is_async(dev))
Why is the is_async() check necessary here?
> + pm_runtime_enable(dev);
> + }
>
> Complete:
> TRACE_SUSPEND(error);
> --
