Hi Lee,
Series is applied, thanks for having done the changes.
Note that I had to rework all the commit titles, because of the
double brackets ("[[PATCH v2] 1/8]").
Something wrong with your script?
Thanks,
Maxime
On 04/21/2016 05:07 PM, Lee Jones wrote:
You'll notice that the voltage cell is populated with 0's. Voltage
information is very platform specific, even depends on 'cut' and
'substrate' versions. Thus it is left blank for a generic (safe)
implementation. If other nodes/properties are provided by the
bootloader, the ST CPUFreq driver will over-ride these generic
values.
Signed-off-by: Lee Jones <lee.jo...@linaro.org>
Signed-off-by: Maxime Coquelin <maxime.coque...@st.com>
---
arch/arm/boot/dts/stih407-family.dtsi | 14 ++++++++++++++
1 file changed, 14 insertions(+)
diff --git a/arch/arm/boot/dts/stih407-family.dtsi
b/arch/arm/boot/dts/stih407-family.dtsi
index 81f8121..9fa1e58 100644
--- a/arch/arm/boot/dts/stih407-family.dtsi
+++ b/arch/arm/boot/dts/stih407-family.dtsi
@@ -22,15 +22,29 @@
device_type = "cpu";
compatible = "arm,cortex-a9";
reg = <0>;
+
/* u-boot puts hpen in SBC dmem at 0xa4 offset */
cpu-release-addr = <0x94100A4>;
+
+ /* kHz uV */
+ operating-points = <1500000 0
+ 1200000 0
+ 800000 0
+ 500000 0>;
};
cpu@1 {
device_type = "cpu";
compatible = "arm,cortex-a9";
reg = <1>;
+
/* u-boot puts hpen in SBC dmem at 0xa4 offset */
cpu-release-addr = <0x94100A4>;
+
+ /* kHz uV */
+ operating-points = <1500000 0
+ 1200000 0
+ 800000 0
+ 500000 0>;
};
};
