On Sat, Mar 12, 2016 at 12:28:39AM +0300, Alexey Khoroshilov wrote:
> fsl_edma_probe() does not disable already enabled clocks
> in case of failure. The patch fixes that.
>
> Found by Linux Driver Verification project (linuxtesting.org).
The typical method to give this credit is Reported-by: ...
In this case you may use the mail id which sent the error report to you, see
examples of kbuild:
Reported-by: kbuild test robot <fengguang...@intel.com>
>
> Signed-off-by: Alexey Khoroshilov <khoroshi...@ispras.ru>
> ---
> drivers/dma/fsl-edma.c | 27 +++++++++++++++++++--------
> 1 file changed, 19 insertions(+), 8 deletions(-)
>
> diff --git a/drivers/dma/fsl-edma.c b/drivers/dma/fsl-edma.c
> index be2e62b87948..58271302e43d 100644
> --- a/drivers/dma/fsl-edma.c
> +++ b/drivers/dma/fsl-edma.c
> @@ -885,20 +885,23 @@ static int fsl_edma_probe(struct platform_device *pdev)
>
> res = platform_get_resource(pdev, IORESOURCE_MEM, 1 + i);
> fsl_edma->muxbase[i] = devm_ioremap_resource(&pdev->dev, res);
> - if (IS_ERR(fsl_edma->muxbase[i]))
> - return PTR_ERR(fsl_edma->muxbase[i]);
> + if (IS_ERR(fsl_edma->muxbase[i])) {
> + ret = PTR_ERR(fsl_edma->muxbase[i]);
> + goto err_clk;
> + }
>
> sprintf(clkname, "dmamux%d", i);
> fsl_edma->muxclk[i] = devm_clk_get(&pdev->dev, clkname);
> if (IS_ERR(fsl_edma->muxclk[i])) {
> dev_err(&pdev->dev, "Missing DMAMUX block clock.\n");
> - return PTR_ERR(fsl_edma->muxclk[i]);
> + ret = PTR_ERR(fsl_edma->muxclk[i]);
> + goto err_clk;
> }
>
> ret = clk_prepare_enable(fsl_edma->muxclk[i]);
> if (ret) {
> dev_err(&pdev->dev, "DMAMUX clk block failed.\n");
> - return ret;
> + goto err_clk;
> }
>
> }
> @@ -923,7 +926,7 @@ static int fsl_edma_probe(struct platform_device *pdev)
> edma_writel(fsl_edma, ~0, fsl_edma->membase + EDMA_INTR);
> ret = fsl_edma_irq_init(pdev, fsl_edma);
> if (ret)
> - return ret;
> + goto err_allclk;
>
> dma_cap_set(DMA_PRIVATE, fsl_edma->dma_dev.cap_mask);
> dma_cap_set(DMA_SLAVE, fsl_edma->dma_dev.cap_mask);
> @@ -952,20 +955,28 @@ static int fsl_edma_probe(struct platform_device *pdev)
> ret = dma_async_device_register(&fsl_edma->dma_dev);
> if (ret) {
> dev_err(&pdev->dev, "Can't register Freescale eDMA engine.\n");
> - return ret;
> + goto err_allclk;
> }
>
> ret = of_dma_controller_register(np, fsl_edma_xlate, fsl_edma);
> if (ret) {
> dev_err(&pdev->dev, "Can't register Freescale eDMA of_dma.\n");
> - dma_async_device_unregister(&fsl_edma->dma_dev);
> - return ret;
> + goto err_async;
> }
>
> /* enable round robin arbitration */
> edma_writel(fsl_edma, EDMA_CR_ERGA | EDMA_CR_ERCA, fsl_edma->membase +
> EDMA_CR);
>
> return 0;
> +
> +err_async:
> + dma_async_device_unregister(&fsl_edma->dma_dev);
> +err_allclk:
> + i = DMAMUX_NR;
> +err_clk:
> + while (--i >= 0)
> + clk_disable_unprepare(fsl_edma->muxclk[i]);
> + return ret;
> }
>
> static int fsl_edma_remove(struct platform_device *pdev)
> --
> 1.9.1
>
> --
> To unsubscribe from this list: send the line "unsubscribe dmaengine" in
> the body of a message to majord...@vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
--
~Vinod
