Le 30-Oct-2000, Mohammad Haque écrivait :
> At the bottom is the IDE/ATA part of my .config. let me knwo if I am
> missing something. Should I worry about the Multi_Mode configuration?
I have it enabled, however I never used any HPT366 controller, so YMMV.
The BX chipset is what I tested the most.
># ATA/IDE/MFM/RLL support
>#
> CONFIG_IDE=y
> CONFIG_BLK_DEV_IDE=y
> CONFIG_BLK_DEV_IDEDISK=y
># CONFIG_IDEDISK_MULTI_MODE is not set
> CONFIG_BLK_DEV_IDECD=y
> CONFIG_BLK_DEV_IDESCSI=m
> CONFIG_BLK_DEV_IDEPCI=y
> CONFIG_IDEPCI_SHARE_IRQ=y
> CONFIG_BLK_DEV_IDEDMA_PCI=y
> CONFIG_BLK_DEV_OFFBOARD=y
> CONFIG_IDEDMA_PCI_AUTO=y
> CONFIG_BLK_DEV_IDEDMA=y
> CONFIG_BLK_DEV_HPT366=y
> CONFIG_BLK_DEV_PIIX=y
> CONFIG_PIIX_TUNING=y
> CONFIG_IDEDMA_AUTO=y
> CONFIG_BLK_DEV_IDE_MODES=y
Looks very similar to my own settings
CONFIG_IDE=y
CONFIG_BLK_DEV_IDE=y
CONFIG_BLK_DEV_IDEDISK=y
CONFIG_IDEDISK_MULTI_MODE=y
CONFIG_BLK_DEV_IDECD=y
CONFIG_BLK_DEV_IDEPCI=y
CONFIG_IDEPCI_SHARE_IRQ=y
CONFIG_BLK_DEV_IDEDMA_PCI=y
CONFIG_IDEDMA_PCI_AUTO=y
CONFIG_BLK_DEV_IDEDMA=y
CONFIG_BLK_DEV_PIIX=y
CONFIG_PIIX_TUNING=y
CONFIG_IDEDMA_AUTO=y
CONFIG_BLK_DEV_IDE_MODES=y
But I only do
hdparm -qu1c1k1 idedevice
at boot time. Also, I've found
append="ide0=autotune ide1=autotune"
in my lilo.conf, left from earlier testing session. Remarks in ide.c say it
only has influence on PIO modes, so unless the comment is obsolete I guess I
could as well remove that line.
Best regards,
Pierre.
--
Linux blade.workgroup 2.4.0-test10 #1 Mon Oct 30 15:30:15 CET 2000 i686 unknown
7:55pm up 4:12, 5 users, load average: 1.11, 1.20, 1.38
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.tux.org/lkml/
