Hi Rob, On 11/22/2015 2:31 PM, Rob Herring wrote: > On Fri, Nov 20, 2015 at 05:17:15PM -0700, Joshua Henderson wrote: >> From: Purna Chandra Mandal <purna.man...@microchip.com> >> >> Document the devicetree bindings for the clock driver found on Microchip >> PIC32 class devices. >> >> Signed-off-by: Purna Chandra Mandal <purna.man...@microchip.com> >> Signed-off-by: Joshua Henderson <joshua.hender...@microchip.com> >> --- >> .../devicetree/bindings/clock/microchip,pic32.txt | 263 >> ++++++++++++++++++++ >> 1 file changed, 263 insertions(+) >> create mode 100644 >> Documentation/devicetree/bindings/clock/microchip,pic32.txt >> >> diff --git a/Documentation/devicetree/bindings/clock/microchip,pic32.txt >> b/Documentation/devicetree/bindings/clock/microchip,pic32.txt >> new file mode 100644 >> index 0000000..4cef72d >> --- /dev/null >> +++ b/Documentation/devicetree/bindings/clock/microchip,pic32.txt >> @@ -0,0 +1,263 @@ >> +Binding for a Clock hardware block found on >> +certain Microchip PIC32 MCU devices. >> + >> +Microchip SoC clocks-node consists of few oscillators, PLL, multiplexer >> +and few divider nodes. > > [...] > >> +Required properties: >> +- compatible : should have "microchip,pic32-clk". >> +- reg : A Base address and length of the register set. >> +- interrupts : source of interrupt. >> + >> +Optional properties (for subnodes): >> +- #clock-cells: From common clock binding, should be 0. >> + >> +- microchip,clock-indices: in multiplexer node clock sources always aren't >> linear >> + and contiguous. This property helps define clock-sources with respect to >> + the mux clock node. >> + >> +- microchip,ignore-unused : ignore gate request even if the gated clock is >> unused. > > There is some discussion about this upstream with "critical-clocks" > binding. Can you use and wait for that? >
The way this is going, we might not have to wait. :) Is there a patch available yet to try it out? >> +- microchip,status-bit-mask: bitmask for status check. This will be used to >> confirm >> + particular operation by clock sub-node is completed. It is dependent >> sub-node. >> +- microchip,bit-mask: enable mask, similar to microchip,status-bit-mask. > > We've generally decided not to describe clocks at this level of detail > in DT. It's fine though for simple clock trees. This one seems to be > borderline IMO. > The binding example is the entire clock tree. These masks are right from the datasheet. For reference, do you have an example of a better alternative? >> +- microchip,slew-step: enable frequency slewing(stepping) during rate >> change; >> + applicable only to sys-clock subnode. > Thanks, Josh -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
