I'm having endless problem with an eepro100 here. After some trying found out
that doing a soft reset (ctrl+alt+del) fixed the problem, and that a power
cycle made it happen again.
Kernel version is 2.2.17pre20
eepro100.c:v1.09j-t 9/29/99 Donald Becker
http://cesdis.gsfc.nasa.gov/linux/drivers/eepro100.html
eepro100.c: $Revision: 1.20.2.10 $ 2000/05/31 Modified by Andrey V. Savochkin
<[EMAIL PROTECTED]> and others
eth0: Intel PCI EtherExpress Pro100 82557, 00:D0:B7:80:C5:9E, I/O at 0xa000, IRQ 5.
Receiver lock-up bug exists -- enabling work-around.
Board assembly 721383-009, Physical connectors present: RJ45
Primary interface chip i82555 PHY #1.
General self-test: passed.
Serial sub-system self-test: passed.
Internal registers self-test: passed.
ROM checksum self-test: passed (0x04f4518b).
eepro100.c:v1.09j-t 9/29/99 Donald Becker
http://cesdis.gsfc.nasa.gov/linux/drivers/eepro100.html
eepro100.c: $Revision: 1.20.2.10 $ 2000/05/31 Modified by Andrey V. Savochkin
<[EMAIL PROTECTED]> and others
The error is that it's unable to receive, while the screen (and logs) are
flooded with pairs of messages like:
eth0: card reports no RX buffers.
eth0: card reports no resources.
The driver is compiled in the kernel (not as a module).
--
Cesar Eduardo Barros
[EMAIL PROTECTED]
[EMAIL PROTECTED]
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.tux.org/lkml/