Not sure if it helps, but look inside Mandrake distribution, and get
their XFree 3.3.4 - http://www.linux-mandrake.com/cooker/
Then try again..
Hetz
Shlomo Reches wrote:
>
> Hi,
>
> My configuration is the following:
>
> - HP Vectra model VEi8 with RedHat 6.0.
> - This machine is claimed to have on board Matrox G200 AGP 2X.
> - IIYAMA vision master pro21 (MT9021E) monitor.
>
> I have tried almost all Matrox cards from xf86config settings as well as
>
> additional Matrox models that are on the demo of the Xinsdie X server.
> None worked for me.
>
> - xf86config fails for every Matrox card it was configured. The system
> stuck immediately
> after X was started.
>
> - Xconfigurator recognizes the card as Matrox G200 however the system
> stuck immediately
> after X was started.
>
> - Xinside couldn't figure out automatically the card type and requested
> manual settings.
> I get a blank screen when I start X however ctl-alt-backspace regain
> control.
>
> Help please?
> Has someone experienced with HP machine?
>
> Thanks,
> Shlomo.
>
> =================================================================
> To unsubscribe, send mail to [EMAIL PROTECTED] with
> the word "unsubscribe" in the message body, e.g., run the command
> echo unsubscribe | mail [EMAIL PROTECTED]
--
Hetz Ben Hamo - Sys. Admin. - Intercomp
[EMAIL PROTECTED]
---------------------------------------
Redmond, you have a problem..
=================================================================
To unsubscribe, send mail to [EMAIL PROTECTED] with
the word "unsubscribe" in the message body, e.g., run the command
echo unsubscribe | mail [EMAIL PROTECTED]
