Hi, did you properly configure BOTH ipmi with ipmitool? And ipmi started? /etc/init.d/ipmi start What says the command: ipmitool -I lan -H IP_OF_OTHER_NODE -U SOMEUSER -A MD5 -P SOMEPASSWORD power status
HTH Nikita Michalko Am Mittwoch, 11. April 2012 23:00:41 schrieb Pham, Tom: > Hi everyone, > > I try to test a 2 nodes cluster with stonith resource using external/ipmi ( > I tried external/riloe first but it does not seem to work) My system has > HP Proliant BL460c G7 with iLO 3 card Firmware 1.15 > SUSE 11 > Corosync version 1.2.7 ; Pacmaker 1.0.9 > > When I use the interface lan or lanplus, It failed to start the stonith > resource. I get the error below external/ipmi[12173]: [12184]: ERROR: > error executing ipmitool: Error: Unable to establish IPMI v2 / RMCP+ > session Unable to get Chassis Power Status > > However, when I used the interface = open instead lan/lanplus ,it started > the stonith resource fine. When I tried to kill -9 corosync in node1, I > expect it will reboot node1 and started all resource on node2. But it > reboot node1. Someone mentioned that open interface is a local interface > and only allows to fence itself. > > Anyone knows why the lan/lanplus does not work? > > Thanks > > Tom Pham > > _______________________________________________ > Linux-HA mailing list > [email protected] > http://lists.linux-ha.org/mailman/listinfo/linux-ha > See also: http://linux-ha.org/ReportingProblems > _______________________________________________ Linux-HA mailing list [email protected] http://lists.linux-ha.org/mailman/listinfo/linux-ha See also: http://linux-ha.org/ReportingProblems
