On Tue, Mar 08, 2011 at 11:56:34AM +0800, Shawn Guo wrote: > On Mon, Mar 07, 2011 at 10:53:37AM -0700, Grant Likely wrote: > > On Mon, Mar 7, 2011 at 9:22 AM, Shawn Guo <shawn....@linaro.org> wrote: > > > The 'rate' is added for fixed-clock support, while 'pll_base' is for > > > pll clock. These two particular type of clocks are supposed to be > > > gracefully supported by the common clk api when it gets ready. > > > > How does the current imx clock code handle fixed and pll clocks? > > For fixed-clock, the current code gets several variables holding the > rate and then return the rate from several get_rate functions. > > static unsigned long external_high_reference, external_low_reference; > static unsigned long oscillator_reference, ckih2_reference; > > static unsigned long get_high_reference_clock_rate(struct clk *clk) > { > return external_high_reference; > } > > static unsigned long get_low_reference_clock_rate(struct clk *clk) > { > return external_low_reference; > } > > static unsigned long get_oscillator_reference_clock_rate(struct clk *clk) > { > return oscillator_reference; > } > > static unsigned long get_ckih2_reference_clock_rate(struct clk *clk) > { > return ckih2_reference; > } > > With this new rate member added, all these can be consolidated into one. > > For base address of pll, the current code uses the reference to clocks > statically defined to know which pll is the one. > > static inline void __iomem *_mx51_get_pll_base(struct clk *pll) > { > #ifdef CONFIG_OF > return pll->pll_base; > #else > if (pll == &pll1_main_clk) > return MX51_DPLL1_BASE; > else if (pll == &pll2_sw_clk) > return MX51_DPLL2_BASE; > else if (pll == &pll3_sw_clk) > return MX51_DPLL3_BASE; > else > BUG(); > > return NULL; > #endif
Be careful about stuff like this. Remember that enabling CONFIG_OF must *not break* board support that does not use the device tree. The above #ifdef block will break existing users. g. _______________________________________________ linaro-dev mailing list linaro-dev@lists.linaro.org http://lists.linaro.org/mailman/listinfo/linaro-dev