Hi Ken, FWIW I'm running fairly recent linaro images on my pandaboard with success.
hwpack in my case was from 0119. Your boot log looks pretty much like mine does, warnings and all. Regards, Tom On Mon, Jan 31, 2011 at 10:31 AM, Ken Werner <k...@linux.vnet.ibm.com> wrote: > Hi there, > > When booting linaro snapshots on my PandaBoard the system hangs a few seconds > after the bash prompt is shown (sometimes a little earlier). My first step was > to enable magic-sysrq but the system doesn't react on them. It looks like it's > already powered off - very strange. I've tried various hwpacks and headless > images and also an SD-card image that works works on a pandaboard of a > colleague (20110127 hwpack with 20110126 headless) but everything fails with > the same symptoms. I used two different power supplies and several SD cards - > also no difference. The board itself doesn't seem to be defective as the > ubuntu-netbook-10.10-preinstalled-netbook-armel+omap4.img runs flawlessly for > hours. I replaced the 2.6.35 omap4 kernel of the ubuntu 10.10 image with a > kernel built from the latest git://git.linaro.org/ubuntu/linux-linaro- > natty.git - but then the board hangs again. Attached is the output of the > serial console. Any hints/suggestions on how to get the linaro kernel working > on this board are much appreciated. > > Regards > Ken > > _______________________________________________ > linaro-dev mailing list > linaro-dev@lists.linaro.org > http://lists.linaro.org/mailman/listinfo/linaro-dev > > _______________________________________________ linaro-dev mailing list linaro-dev@lists.linaro.org http://lists.linaro.org/mailman/listinfo/linaro-dev