Could you please change the mails' subject? :) I've started a thread: Lilypond patchy and other Lilypond problems for this discussion. Could you move there?
Łukasz On 27 April 2012 19:43, Phil Holmes <m...@philholmes.net> wrote: > ----- Original Message ----- From: "James" <pkx1...@gmail.com> > To: "Phil Holmes" <m...@philholmes.net> > Cc: <m...@apollinemike.com>; <k-ohara5...@oco.net>; <d...@gnu.org>; < > lilypond-devel@gnu.org> > Sent: Friday, April 27, 2012 5:58 PM > > Subject: Re: Macro for(UP_and_DOWN) and 3 similar. (issue 2491) (issue > 6109046) > > > You then need to tick a box more or two to enable that stuff in VBox >> or KVM. Remember though that LilyDev is 32bit so if you use KVM you >> must not go over 4096 for your RAM (even if you have more) else, I >> found, it will just default to 128mb! Vbox is a bit more smart, but >> you still cannot address more than 4GB of RAM in a 64bit VBox install >> using LilyDev. >> >> > That said, I've never seen Lily builds take much RAM, so 4 GByte is > normally plenty. > > -- > Phil Holmes > > ______________________________**_________________ > lilypond-devel mailing list > lilypond-devel@gnu.org > https://lists.gnu.org/mailman/**listinfo/lilypond-devel<https://lists.gnu.org/mailman/listinfo/lilypond-devel> >
_______________________________________________ lilypond-devel mailing list lilypond-devel@gnu.org https://lists.gnu.org/mailman/listinfo/lilypond-devel
