On Tue, Jun 30, 2009 at 11:53:34AM -0600, Carl D. Sorensen wrote: > > On 6/30/09 11:02 AM, "Patrick McCarty" <pnor...@gmail.com> wrote: > > > > When I compile LilyPond with the intent of debugging it, I use > > > > ./configure --disable-optimising > > > > instead. Did you try that? > > I had not. I also hadn't realized that --enable-debugging is on by default. > > So I disabled optimization, and reran make. > > Same result, unfortunately. > > However, on a hunch I decided to look at the .gdbinit file. I had been > using the .gdbinit file from the CG. When I eliminated the .gdbinit file, > everything ran properly. So apparently, it's a problem with the .gdbinit > file. > > Could somebody with more knowledge of what's going on than me look at the > .gdbinit file and tell me what's wrong?
I'm not sure, but here is the output for me when I use the .gdbinit file: $ gdb lilypond GNU gdb 6.8 Copyright (C) 2008 Free Software Foundation, Inc. License GPLv3+: GNU GPL version 3 or later <http://gnu.org/licenses/gpl.html> This is free software: you are free to change and redistribute it. There is NO WARRANTY, to the extent permitted by law. Type "show copying" and "show warranty" for details. This GDB was configured as "x86_64-unknown-linux-gnu"... Function "scm_error" not defined. Make breakpoint pending on future shared library load? (y or [n]) [answered N; input not from terminal] Breakpoint 1 at 0x6e447d: file warn.cc, line 68. Breakpoint 2 at 0x4f7e9e: file grob.cc, line 562. As you can see, gdb does not create a breakpoint for "scm_error", which is a part of Guile. I would try removing the breakpoint for "scm_error" in the init file to see if that works, and keep everything else. Thanks, Patrick _______________________________________________ lilypond-devel mailing list lilypond-devel@gnu.org http://lists.gnu.org/mailman/listinfo/lilypond-devel
