The sender domain has a DMARC Reject/Quarantine policy which disallows
sending mailing list messages using the original "From" header.
To mitigate this problem, the original message has been wrapped
automatically by the mailing list software.
--- Begin Message ---
2017-07-21 00:36, Sergey Ryazanov rašė:
No received/sent packets on br-lan and eth0 before and after modprobe
mv88e6060.ko.
Did you saw the "Marvel 88E6060 PHY driver attached" string in the
kernel messages? If so then at least the driver detects switch chip.
No. BTW, do I understand correctly - I have to use mv88e6060.ko which
should use CONFIG_MVSWITCH_PHY or is CONFIG_MVSWITCH_PHY alone enough?
This driver uses VLAN tags to determine which port the frame should be
sent from. Try to create couple of VLAN sub-interfaces on eth0 with ID
1 and 2 and work with them.
I'll try.
And BTW do you use OpenWRT or LEDE and which version?
Actually I use barrier breaker, as the device has only 16 MB RAM so
I thought an earlier version will use less resources. But I can try
later versions.
Thanks,
Nerijus
--- End Message ---
_______________________________________________
Lede-dev mailing list
Lede-dev@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/lede-dev
