On 2017-05-29 11:24, Sven Roederer wrote:
This patch adds support for the Ubiquiti EdgeRouter X-SFP and
improves support for the EdgeRouter X (PoE-passthrough).
Specification:
- SoC: MediaTek MT7621AT
- Flash: 256 MiB
- RAM: 265 MiB
- Ethernet: 5 x LAN (1000 Mbps)
- UART: 1 x UART on PCB (3.3V, RX, TX, GND) - 57600 8N1
- EdgeRouter X:
- 1 x PoE-Passtrough (Eth4)
- powered by Wallwart or passive PoE
- EdgeRouter X-SFP:
- 5 x PoE-Out (24V, passive)
- 1 x SFP (unknown status)
- powered by Wallwart (24V)
regarding the sfp port, it does not show up on the luci switch page.
this port seems to be missing.
what i have is CPU (eth0) and then lan 1 to 4 and a WAN
WAN is the port labeled eth0 on the device and then lan 1-4 must be eth1-4
sfp port is labeled eth5 and as far as i can tell doesn't work.
is this just a minor config issue so this port is perhaps not configured
at all with vlan and so on?
_______________________________________________
Lede-dev mailing list
Lede-dev@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/lede-dev
