Initramfs image boots fine from the RAM. Regards Mani
On Thu, Mar 9, 2017 at 9:53 PM, Matthew McClintock <msm-...@mcclintock.net> wrote: > On Thu, Mar 9, 2017 at 10:15 AM, K.Mani <sailorm...@gmail.com> wrote: >> Hi Matthew, >> >> (IPQ40xx) # smeminfo >> flash_type: 0x6 >> flash_index: 0x0 >> flash_chip_select: 0x0 >> flash_block_size: 0x10000 >> flash_density: 0x1000000 >> partition table offset 0x0 >> No.: Name Attributes Start Size >> 0: 0:SBL1 0x0000ffff 0x0 0x40000 >> 1: 0:MIBIB 0x001040ff 0x40000 0x20000 >> 2: 0:QSEE 0x0000ffff 0x60000 0x60000 >> 3: 0:CDT 0x0000ffff 0xc0000 0x10000 >> 4: 0:DDRPARAMS 0x0000ffff 0xd0000 0x10000 >> 5: 0:APPSBLENV 0x0000ffff 0xe0000 0x10000 >> 6: 0:APPSBL 0x0000ffff 0xf0000 0x80000 >> 7: 0:ART 0x0000ffff 0x170000 0x10000 >> 8: 0:HLOS 0x0000ffff 0x180000 0x400000 >> 9: rootfs 0x0000ffff 0x580000 0xa80000 >> >> Is this a nand or nor booting board? >> Don't know. >> >> SF: MX25L25635E, it's spi-nor i guess. > > Sounds right. > >> >> If i have to flash 'initramfs', should it be on HLOS partition start address? >> >> Also attached a old boot log. > > No you can just load to memory and boot from there, no need to mess > with flash at this point. > > -M _______________________________________________ Lede-dev mailing list Lede-dev@lists.infradead.org http://lists.infradead.org/mailman/listinfo/lede-dev
