> El 18/06/2016, a las 12:51 p.m., Josh Bendavid <joshbenda...@gmail.com> > escribió: > > Ok. If the configuration I am suspecting for the stock firmware is > correct, then port 6 is unused and it shouldn't matter how it's > configured. > > Actually it's possible that some of this is anyways dynamically > configurable through the switch registers. (ie even if the stock > firmware has the eth1 connected directly to the WAN phy as I suspect, > it might still be possible/preferable to configure the switch so that > it is more like AP148 with gmacX (eth1) -> rgmii -> switch port 6
Is there any way I can dump all registers from the switch? I could flash back stock FW and see how it is set up. > > Actually I don't think gmac2 even supports rgmii, so if both ethernet > interfaces are connected to the switch chip/PHY's with rgmii then they > would have to be gmac0 and gmac1... _______________________________________________ Lede-dev mailing list Lede-dev@lists.infradead.org http://lists.infradead.org/mailman/listinfo/lede-dev
