The caller ID card was only included with the dash 7 revision. You DO need to open the box, not just the cover, to install..or even check..the caller ID card.
Jim ----- Original Message ----- From: "Bill Cerny, Grantville Associates" <[EMAIL PROTECTED]> To: <kxt@kxthelp.com> Sent: Monday, April 07, 2008 1:32 PM Subject: KX-T: Caller-ID on KX-TD816-5 > KX-TFolks, > > Went out yesterday and used SYS-PRG 407 to enable Caller-ID on a > couple of CO lines on a KX-TD816-5 (installed circa 2001). I > thought this box had the Caller-ID module (KX-TD193) included for > the first 4 CO lines (or did the free Caller-ID start with later > models?) > > I verified CLID signaling from the CO, but no CLID display on the > sets. Looked inside the KSU - found the door phone adapter. If > there is a KX-TD193 installed for CO 1-4, would I have to open up > the KSU enclosure and examine the system board? > > Thanks! > Bill > > -------------------------------------------------------------------------------- > _________________________________________________________________ > KX-T Mailing list --- http://kxthelp.com/ > Subscription changes: http://kxthelp.com/mailman/listinfo/kxt > _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
