yes.. u could have made the two lines in NOT CONNECTED mode in through programming.. 400 If I am correct.. but it would not have changed the line nos. though Hope this is sufficient.. Nitin
Jim McAtee <[EMAIL PROTECTED]> wrote: We have a KX-TD1232 and until recently had eight CO lines. We just decommissioned two of the lines - for reasons unrelated to the KX-TD these were the old lines 3 and 8. To have the remaining lines numbered 1 to 6, I used some cross-connect wire on a 66 block to move the incoming lines 3 to 7. I'm curious about whether this could have be done programmatically within the KX-TD? _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
