6 volts would be just as good as 5.5 volts. That small amount won't make any diference. That sounds like a good idea for you, since you would always be able to get new AAA or AA batteries.
Charles ----- Original Message ----- From: "Support" <[EMAIL PROTECTED]> To: <kxt@kxthelp.com> Sent: Friday, July 08, 2005 2:18 PM Subject: KX-T: Internal Mainboard Battery replacement for KXT 616 PBX >I found the problem about my KX-T 616's previous issue with the dialing out >problem. > It is due to the PBX is reset after there's no electrical power for more > than 2 days. > All of the programmed stuffs lost after there's no power for more than a > day. > So, I opened up the PBX and checked the battery soldered on the mainboard. > It is written as 5.5V on the battery but when checked, it showed only > 2.6~2.9 mV on the display. > Hence, I assume it is the battery problem and due to that case all of the > programmed stuffs are lost after there's no AC power for a couple of days. > I was trying to find the replacement battery for that one but I cannot > find any similar one here. > However I've got the 4.8V rechargeable battery but which is slightly > larger (about the double in size) than the original battery. > Before replacing with that new battery, I want to get the suggestions and > the comments about replacing the builtin 5.5V battery on the KX-T 616 PBX. > Kindly let me know whether it is OK to replace the 5.5V (not working) > battery with the 4.8V battery or should I connect that two in parallel due > one is not properly working and another one is less than it's needed > volts. > Another idea is I could use the AA or AAA size rechargeable 1.5V batteries > and put them in the new external battry socket. > However it would be just 4.5V with 3 batteries or 6V with 4 batteries. > So, I'm afraid of it could damage the system if over voltage or the system > won't funciton if with less voltage. > I am living in Myanmar (Burma) where spare parts are hard to get unless it > is the common equipments. > Oversea orders are also very hard to take place unless somebody go out to > at least Bangkok or Singapore and get it. > So, it is left with using the single 4.8 Volt battery or using of (3 or 4) > 1.5V AA/AAA size batteries. > And whether it should be used with the new battries alone or parallel with > that 5.5 volt builtin battery which is not working properly. > Will be very much appreciate upon any suggestions and ideas. > > > > _________________________________________________________________ > KX-T Mailing list --- http://kxthelp.com/ > Subscription changes: http://kxthelp.com/mailman/listinfo/kxt > > _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
