try 406 caller id assign, co 09 = enable, co 10 = enable, co 11 = enable, co 12 = enable
also, stations will start ringing on SECOND ring from co. -larry 5/26/05 2:46:15 PM, "JGALVEZ" <[EMAIL PROTECTED]> wrote: >Dear members, > >I got a Kx-td1232 -5 with 12 CO's > >I got a brand new Caller ID card that I setup on the external CO expansion >module (CO 09 - 12) > >I purchased only one card to find out if this setup will work. (in the >manuals says so) but I wasn;t able to mak this happen. > >Happens that I need to "print" the caller ID of every single call that >gets into the PBX > >As per the General Features Manual Page 58 CALL LOG, INCOMING talks about >the way that would print the caller Id > >Adn ond Page 218 Station Message Detal Recording (SMDR) says that I should >spect an <I> ######### with the identified number that is arriving from >the COffice > >The problem is that I'm receiving only the <I> line with no Caller ID. > >I connected a "normal" phone with the Caller ID feature & display and >whenever anyone calls to this number will show the Caller ID. > >Question and concerns, > >1) the Caller ID module should go on ANY slot? or I have to place it on an >special order? > >2) What bit's should I activate to receive the <I> ### #### on the SMDR >print out? > >3) Will this work (the caller id) even if I have a voice mail installed? >will the incomming number be printed?? > >Please be kind to help me configure this > >I live in La Paz, Bolivia, South America. > >Thank you a lot > >Javier Galvez >+(591)-715-22149 > > >_________________________________________________________________ >KX-T Mailing list --- http://kxthelp.com/ >Subscription changes: http://kxthelp.com/mailman/listinfo/kxt > > > _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
