On 6/18/2020 10:29 AM, Mark Langford via KRnet wrote:
Now that I think about it, a "circle cutter" is also what I used for
my first panel, but I do have a drill press, and the hazards are
many....including trashing the whole panel, or breaking the bit and
damaging an eye!
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
Circle cutter is probably the more proper name. The trick I found was
to proceed VERY SLOWLY and make sure your material is 90 degrees to the
drill bit. Several of the ones shown have two cutters, mine only had
one cutter. The double cutter is probably a much better way to go.
Again , approach the material to be cut VERY, VERY CAREFULLY and have a
good feel on the drill press. I cut every hole in my panel with that
cutter except the smaller switch holes.
Larry Flesner
Southern Illinois
_______________________________________________
Search the KRnet Archives at https://www.mail-archive.com/krnet@list.krnet.org/.
Please see LIST RULES and KRnet info at http://www.krnet.org/info.html.
see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to change
options.
To UNsubscribe from KRnet, send a message to krnet-le...@list.krnet.org
