Yes Proseal can be very slow to cure at 65*, especially the 2 hr stuff. We usually use B1/2 (1/2 hr working time) on most aircraft I work on and figure at least 72 hrs for a descent cure at above 75*F. If you are using the "A" type it is quite runny for a long time! If you can warm it up a bit it may help speed up the cure.
In a message dated 11/20/2011 1:50:55 P.M. Mountain Standard Time, bandenok...@gmail.com writes: Thanks all, I think I found my answer. According to an article on Van's website, it will take up to 3-4 days for it to cure tack free and another 2-3 days for it to fully cure. What a pain....! Note to self: Get tanks welded on next project. Rodger Sent from my iPhone On Nov 20, 2011, at 11:27 AM, Rodger <bandenok...@gmail.com> wrote: > FYI: I mixed the entire 1 pint resin and hardener (100/10 mixture) while working in about 65 degrees ambient temp. > Rodger > > Sent from my iPhone > > On Nov 20, 2011, at 10:09 AM, Rodger <bandenok...@gmail.com> wrote: > >> Netters, >> Is Proseal supposed to harden like epoxy or is it supposed be a gooey tar like mess? I used the two hour stuff on my first tank, yet it has not set up. I tried a heater after 12 hours and it just runs more. What can I do to fix this? >> Rodger >> bandenok...@gmail.com >> >> >> Sent from my iPhone > > _______________________________________ > Search the KRnet Archives at http://www.maddyhome.com/krsrch/index.jsp > to UNsubscribe from KRnet, send a message to krnet-le...@mylist.net > please see other KRnet info at http://www.krnet.org/info.html _______________________________________ Search the KRnet Archives at http://www.maddyhome.com/krsrch/index.jsp to UNsubscribe from KRnet, send a message to krnet-le...@mylist.net please see other KRnet info at http://www.krnet.org/info.html
