Just my $.02..... Are you sure the hub isn't exiting THE SEAL off center? I've seen this before. You may just have a damaged/mis-installed seal.
Scott --- AVLEC <av...@telkomsa.net> wrote: > Hi gang > We over here have a problem with a new zero time > aerovee motor that is > fitted to the new Whisper express prototype. > I am no VW expert, Mark L or someone else might be > able to shed some light > here. > If you look at the motor from the prop flange, the > prop hub exits the case > off centre by approx 0.3mm. (a 0.3mm feeler guage > can be squeezed into the > gap). It is quite noticeable at a glance. It also > leaks oil from this area > although it runs fine. > I suspected a faulty line bore but surely if the > line bore was off centre to > the case split line, it would still be concentric to > the crank since the > crank runs in bearings which are located by the line > bored case??? Any > suggestions. > Regards > Dene Collett > KR2SRT builder > South africa > Whisper assembler > See: www.whisperaircraft.com > > mailto: av...@telkomsa.net > > > _______________________________________ > Search the KRnet Archives at > http://www.maddyhome.com/krsrch/index.jsp > to UNsubscribe from KRnet, send a message to > krnet-le...@mylist.net > please see other KRnet info at > http://www.krnet.org/info.html > __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com
