Looks like an engineering stress analysis question, Virg On Sat, 15 Oct 2005 13:28:04 -0400 (EDT) Don Chisholm <chizmsupholst...@rogers.com> writes: > just to get a dicussion going. I have a hypothetical question to the > net and I'm sure it's been either done or thought about. > If one decided to mate a KR wing set to a truss type steel tube > fuselage > how would one go about doing it? > . My thoughts are to go with a Sonerai 2 style set up > as it is a center section with 2 outer wing panel style wing set > not too dissimilar to > a KR wing . Using 1/8 inch wing attach fittings more or less as per > wing attach > fittings but installed on the juncture of where the fuselage and > center spars intersect, > bolt the spar to the fuselage with 5/16 inch mounting bolts through > the upper and lower spar > caps on center through the fittings through the spar. > How would one bolt the wing to fuselage attach fittings to the spar, > would you use the > same bolt pattern as on the wing attach fittings or use 1/4 inch > bolts on center of the > fitting 3 on one side of the 5/16 inch mounting bolt and 3 on the > other side. > I hope my question is clear enough > _______________________________________ > Search the KRnet Archives at > http://www.maddyhome.com/krsrch/index.jsp > to UNsubscribe from KRnet, send a message to krnet-le...@mylist.net > please see other KRnet info at http://www.krnet.org/info.html > >
Virgil N. Salisbury - AMSOIL www.lubedealer.com/salisbury Miami ,Fl
