Hi Netters, Some one asked about the primer for painting WAFs.Below is what I use.
Green Epoxy Primer. Manufactured by Dupont. Epoxy Dupont 2580CR, LF Epoxy DTM Primer Sealer. Mix 2 parts by volume to 1 volume of catalyst, Catalyst , Dupont 2505S, DTM Epoxy Primer (activator- mid temperature) Pot life is several hours (depending on temperature) if the mixture is kept covered after mixing. Apply by spray or brush. Apply over clean (grease free) , sanded steel, galvanized steel, stainless steel, aluminum. 1 medium coat (0.8- 1.2 mil.) as a sealer 1 medium wet coat (0.8- 1.2 mils.) over Aluminum, stainless steel, galvanized steel. 30 minutes flash before recoating. Can apply up to 2 wet coats (0.8 - 2.2 mils.) as a primer over galvanized steel.Allow 40 to 60 minutes before top coating. Spray pressures. Siphon.....30-45 PSI Gravity....30-40 PSI HVLP....... 8-10 PSI I paid about $100.00 for the kit which contained about 1 liter of Epoxy and about 0.5 liters of catalyst. This kit was purchased from Garage Supply in Orillia. Regards Harold Woods Orillia,ON.Canada haroldwo...@rogers.com
