Are you using resistor plugs? Great Plains recommeds only Bosch W8AC plugs. I used them and had no noise.
I am not familiar with the Revemaster conversion. Great Plains uses an aluminum machined piece that completely covers the plug. The standard shielded ignition wires connect to this piece and keep the plug completely shielded. Steve recommends connectiong a wire from the aluminum piece to the engine if there is noise, but I never had to do that. Does the Revmaster use a shielded harness? Are you using it off of a mag? Brian Kraut Engineering Alternatives, Inc. www.engalt.com -----Original Message----- From: krnet-boun...@mylist.net [mailto:krnet-boun...@mylist.net]On Behalf Of Kenneth L Wiltrout Sent: Saturday, June 12, 2004 2:23 PM To: kr...@mylist.net Subject: KR> Ignition noise Due to the high cost of aviation plugs I decided to buy the Revmaster conversion kit to auto plugs---------------------that being said the engine runs excellant but now I have unbearable ignition noise. If I had to do it over I never would have done this. Any of you radio techs out the know of a solution?? If I have too I will re install a new aviation harness and plugs. ( but I'd rather not $$$ ) THANKS!! ________________________________________________________________ The best thing to hit the Internet in years - Juno SpeedBand! Surf the Web up to FIVE TIMES FASTER! Only $14.95/ month - visit www.juno.com to sign up today! _______________________________________ to UNsubscribe from KRnet, send a message to krnet-le...@mylist.net please see other KRnet info at http://www.krnet.org/info.html
