I ain't fair. Looks real good.. I say, as I drool all over myself. N64KR
Daniel R. Heath - Columbia, SC da...@kr-builder.org See you in Red Oak - 2003 See our KR at http://KR-Builder.org - Click on the pic See our EAA Chapter 242 at http://EAA242.org -------Original Message------- http://rvflying.tripod.com/fuselage9.jpg You start from the spar center section and build back these last bulkhead, where the HS and VS attach. As you assemble the fuselage, you start back here and build forward. It was very, very cool for me to put this part of the airplane together. http://rvflying.tripod.com/fuselage10.jpg Anyway, after I took the above pics before lunch yesterday, I kept sneaking out of the office back to the shop so that I could complete these. Believe it or not, it took a little time to fabricate the two angles of the side of each pedal, countersink, deburr and rivet the pedals together then get the throw just right so both pedals sat neutral. http://rvflying.tripod.com/fuselage11.jpg Anyway, it sure is fun to open the shop door and see this big ol thing sitting there. As a note, I have had to fabricate more little parts so far than I had to in the entire emp. and wings together. Can I call myself a measely little tiny bit airplane builder?? How he sells this whole thing including all hardware, brakes, tailwheel, fittings, canopy, rivet, nut bolt and every little fitting you can imagine for 17.9 I'll never know. Dana Overall 1999 & 2000 National KR Gathering host Richmond, KY RV-7 slider/fuselage Finish kit ordered!! Buying Instruments http://rvflying.tripod.com do not archive _________________________________________________________________ MSN 8 helps eliminate e-mail viruses. Get 2 months FREE*. http://join.msn.com/?page=features/virus _______________________________________________ see KRnet list details at http://www.krnet.org/instructions.html .
