That's true Larry. Plus my servo will be square to the spar. Then I can make an easy bracket attaching it to the spar. Thanks guys
Paul Visk Belleville Il. 618-406-4705 In a message dated 7/3/2014 7:37:20 P.M. Central Daylight Time, flesner at frontier.com writes: > Should I cut the trim tab out square with the spar? Or square with > the trailing edge? and whatever I decide I know my ray allen trim > tabs servo would have to be square to the tab. ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++ ++++++++++++++++++++++++++++++++++++++++++++++++++++++++ Do you prefer blonds or brunets? Same deal, it will work either way. I went parallel to the trail edge but parallel to the spar would allow better alignment with air stream of the linkage. https://dl.dropboxusercontent.com/u/32133949/IMG_8611.JPG https://dl.dropboxusercontent.com/u/32133949/IMG_8612.JPG https://dl.dropboxusercontent.com/u/32133949/IMG_8613.JPG https://dl.dropboxusercontent.com/u/32133949/IMG_8615.JPG If things aren't quite square you can bend the pushrod a bit or put a slight twist in the bellcrank arm but square is always good. Larry Flesner
