This hyperlink is the second best sanding/finishing article I have come across.
http://curedcomposites.com/finish.html
?
The link I saved for?the best method?is now dead, but?it advised applying?a
first thick coat of micro with a 1/4 or 3/8 slotted trowel.
It said that the due to the valleys in the micro, that with coarse paper on a
long, about 4+ feet, flat sanding block, one could sand almost all of the micro
off in just?minutes, leaving grooved micro only in the low spots.
This method was said to?quickly identify the low spots and make final filling a
piece of cake. prety much as described in the above link.
?
Edward Spyker
jesj69 at yahoo dot com
