Help.....I layed up two layers of 5 oz fiberglass and a layer of peel ply on one side of my elevator last Saturday.Tonight I went to remove the peel ply material and noticed I have some areas that appear lighter in color . I think the fiberglass lifted off from the foam in these areas,or it did not bond to the foam during setup. I also could have applied the peel ply too soon? During the layup the surface looked wetted out evenly. Is this a problem area to be concerned about? I might have lifted the fiberglass from the foam while pulling the peel ply off. It doesn't look like an air pocket. Any advice would be appreciated. Thanks, Joe
KR1.5 N3151K rebuilding the tail feathers KR2S N6102L outer wing construction/aluminum wing tanks Joe Cruz Spencer,NY
