The others also have a minimum resolution too, unless you think you can align things to femtometers ;)
On Sun, Apr 10, 2016 at 03:38:08AM +1200, Simon Wells wrote: > do they not have the difference of being limited to only 1 decimal > place unlike the others though? > > On Sun, Apr 10, 2016 at 3:27 AM, Chris Pavlina <pavlina.ch...@gmail.com> > wrote: > > Values already have to be validated. The only issue I can think of is > > related > > to the decimal point / comma issue, but we're *already* accepting decimal > > points in values in other fields in the same dialogs (for positional > > offsets, > > for instance). I figure it should be fine as long as they're handled in the > > same way. > > > > On Sun, Apr 10, 2016 at 03:16:53AM +1200, Simon Wells wrote: > >> This was seen in a previous thread iirc and wayne mentioned that > >> someone would need to write it so that it verified values were entered > >> correctly etc > >> > >> On Sun, Apr 10, 2016 at 2:37 AM, Chris Pavlina <pavlina.ch...@gmail.com> > >> wrote: > >> > Anyone mind if I go through and fix the "in 0.1 degrees" units that are > >> > all > >> > over pcbnew? I don't see any reason why we can't let the user enter unit > >> > degrees with a decimal point. > >> > > >> > -- > >> > Chris > >> > > >> > _______________________________________________ > >> > Mailing list: https://launchpad.net/~kicad-developers > >> > Post to : kicad-developers@lists.launchpad.net > >> > Unsubscribe : https://launchpad.net/~kicad-developers > >> > More help : https://help.launchpad.net/ListHelp _______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : kicad-developers@lists.launchpad.net Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp
