do they not have the difference of being limited to only 1 decimal place unlike the others though?
On Sun, Apr 10, 2016 at 3:27 AM, Chris Pavlina <pavlina.ch...@gmail.com> wrote: > Values already have to be validated. The only issue I can think of is related > to the decimal point / comma issue, but we're *already* accepting decimal > points in values in other fields in the same dialogs (for positional offsets, > for instance). I figure it should be fine as long as they're handled in the > same way. > > On Sun, Apr 10, 2016 at 03:16:53AM +1200, Simon Wells wrote: >> This was seen in a previous thread iirc and wayne mentioned that >> someone would need to write it so that it verified values were entered >> correctly etc >> >> On Sun, Apr 10, 2016 at 2:37 AM, Chris Pavlina <pavlina.ch...@gmail.com> >> wrote: >> > Anyone mind if I go through and fix the "in 0.1 degrees" units that are all >> > over pcbnew? I don't see any reason why we can't let the user enter unit >> > degrees with a decimal point. >> > >> > -- >> > Chris >> > >> > _______________________________________________ >> > Mailing list: https://launchpad.net/~kicad-developers >> > Post to : kicad-developers@lists.launchpad.net >> > Unsubscribe : https://launchpad.net/~kicad-developers >> > More help : https://help.launchpad.net/ListHelp _______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : kicad-developers@lists.launchpad.net Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp
