I would open a JTAC case On Tue, Sep 18, 2018 at 10:48 AM, Joerg Staedele <[email protected]> wrote:
> Hi, > > i am seeing a lot of these messages in the chassisd log: > > Sep 18 10:44:25 PEM power status has changed, run power budget again > Sep 18 10:44:28 PEM power status has changed, run power budget again > Sep 18 10:44:44 PEM power status has changed, run power budget again > Sep 18 10:44:47 PEM power status has changed, run power budget again > Sep 18 10:45:22 PEM power status has changed, run power budget again > Sep 18 10:45:28 PEM power status has changed, run power budget again > > I already updated from 17.4R1 to R2 but it's still there. There is no > alarm active and both PS look normal but the voltage on PEM 0 is "only" > 11V, maybe there's a problem? > > PEM 0 status: > State Online > Airflow Front to Back > Temperature OK 48 degrees C / 118 degrees F > Temperature OK 49 degrees C / 120 degrees F > Fan Sensor 6660 RPM > DC Output Voltage(V) Current(A) Power(W) Load(%) > 11.00 7 77 11 > PEM 1 status: > State Online > Airflow Front to Back > Temperature OK 47 degrees C / 116 degrees F > Temperature OK 49 degrees C / 120 degrees F > Fan Sensor 6570 RPM > DC Output Voltage(V) Current(A) Power(W) Load(%) > 12.00 8 96 14 > > Anyone else having this problem? > > Kind regards. > > Joerg > > _______________________________________________ > juniper-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/juniper-nsp > _______________________________________________ juniper-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/juniper-nsp
