On 30.03.2024 23:14, Andrew Lunn wrote:
> On Fri, Mar 29, 2024 at 10:23:20AM +0100, Wojciech Drewek wrote:
>> Some modules use nonstandard power levels. Adjust ethtool
>> module implementation to support new attributes that will allow user
>> to change maximum power.
>>
>> Add three new get attributes:
>> ETHTOOL_A_MODULE_MAX_POWER_SET (used for set as well) - currently set
>> maximum power in the cage
>> ETHTOOL_A_MODULE_MIN_POWER_ALLOWED - minimum power allowed in the
>> cage reported by device
>> ETHTOOL_A_MODULE_MAX_POWER_ALLOWED - maximum power allowed in the
>> cage reported by device
>
> I'm confused. The cage has two power pins, if you look at the table
> here:
>
> https://www.embrionix.com/resource/how-to-design-with-video-SFP
>
> There is VccT and VccR. I would expect there is a power regulator
> supplying these pins. By default, you can draw 1W from that
> regulator. The board however might be designed to support more power,
> so those regulators could supply more power. And the board has also
> been designed to dump the heat if more power is consumed.
>
> So, ETHTOOL_A_MODULE_MIN_POWER_ALLOWED is about the minimum power that
> regulator can supply? Does that make any sense?
>
> ETHTOOL_A_MODULE_MAX_POWER_ALLOWED is about the maximum power the
> regulator can supply and the cooling system can dump heat?
>
> Then what does ETHTOOL_A_MODULE_MAX_POWER_SET mean? power in the cage?
> The cage is passive. It does not consume power. It is the module which
> does. Is this telling the module it can consume up to this amount of
> power?
Right, all of those attributes describe restrictions for modules that
can be plugged into the given cage. ETHTOOL_A_MODULE_MAX_POWER_SET is
currently set maximum. The other two define the range of values that
ETHTOOL_A_MODULE_MAX_POWER_SET can take.
I hope that answers your question.
>
> Andrew
>
