- Pipe underrun can't just be enabled, we need some support code like
on ilk-hsw to make this happen. So drop it for now.
- CRC error is a special mode of the CRC hardware that we don't use,
so again drop it. Real CRC support for bdw will be added later.
- All the other error bits are about faults, so rename the #define and
adjust the output.
Signed-off-by: Daniel Vetter <daniel.vet...@ffwll.ch>
---
drivers/gpu/drm/i915/i915_irq.c | 10 ++++++----
drivers/gpu/drm/i915/i915_reg.h | 9 ++++-----
2 files changed, 10 insertions(+), 9 deletions(-)
diff --git a/drivers/gpu/drm/i915/i915_irq.c b/drivers/gpu/drm/i915/i915_irq.c
index c04fbbf0acf7..370c9281a256 100644
--- a/drivers/gpu/drm/i915/i915_irq.c
+++ b/drivers/gpu/drm/i915/i915_irq.c
@@ -1793,8 +1793,11 @@ static irqreturn_t gen8_irq_handler(int irq, void *arg)
intel_finish_page_flip_plane(dev, pipe);
}
- if (pipe_iir & GEN8_DE_PIPE_IRQ_ERRORS)
- DRM_ERROR("Errors on pipe %c\n", 'A' + pipe);
+ if (pipe_iir & GEN8_DE_PIPE_IRQ_FAULT_ERRORS) {
+ DRM_ERROR("Fault errors on pipe %c\n: 0x%08x",
+ 'A' + pipe,
+ pipe_iir & GEN8_DE_PIPE_IRQ_FAULT_ERRORS);
+ }
if (pipe_iir) {
ret = IRQ_HANDLED;
@@ -2863,9 +2866,8 @@ static void gen8_de_irq_postinstall(struct
drm_i915_private *dev_priv)
{
struct drm_device *dev = dev_priv->dev;
uint32_t de_pipe_enables = GEN8_PIPE_FLIP_DONE |
- GEN8_PIPE_SCAN_LINE_EVENT |
GEN8_PIPE_VBLANK |
- GEN8_DE_PIPE_IRQ_ERRORS;
+ GEN8_DE_PIPE_IRQ_FAULT_ERRORS;
int pipe;
dev_priv->de_irq_mask[PIPE_A] = ~de_pipe_enables;
dev_priv->de_irq_mask[PIPE_B] = ~de_pipe_enables;
diff --git a/drivers/gpu/drm/i915/i915_reg.h b/drivers/gpu/drm/i915/i915_reg.h
index f150edaa64ca..9e7588345017 100644
--- a/drivers/gpu/drm/i915/i915_reg.h
+++ b/drivers/gpu/drm/i915/i915_reg.h
@@ -4064,11 +4064,10 @@
#define GEN8_PIPE_SCAN_LINE_EVENT (1 << 2)
#define GEN8_PIPE_VSYNC (1 << 1)
#define GEN8_PIPE_VBLANK (1 << 0)
-#define GEN8_DE_PIPE_IRQ_ERRORS (GEN8_PIPE_UNDERRUN | \
- GEN8_PIPE_CDCLK_CRC_ERROR | \
- GEN8_PIPE_CURSOR_FAULT | \
- GEN8_PIPE_SPRITE_FAULT | \
- GEN8_PIPE_PRIMARY_FAULT)
+#define GEN8_DE_PIPE_IRQ_FAULT_ERRORS \
+ (GEN8_PIPE_CURSOR_FAULT | \
+ GEN8_PIPE_SPRITE_FAULT | \
+ GEN8_PIPE_PRIMARY_FAULT)
#define GEN8_DE_PORT_ISR 0x44440
#define GEN8_DE_PORT_IMR 0x44444
--
1.8.4.rc3
_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
http://lists.freedesktop.org/mailman/listinfo/intel-gfx
