>I discussed this further with Jim Mulder. The z12, where I recently noticed >the 'unassigned' value, introduced 2 GB pages, one of whose consequences is >that LPAR boundaries are rounded up as needed to the nearest 2 GB boundary. If >an image profile specifies any other value, the 'excess' is displayed as >unassigned storage. It can be configured online to the owning LPAR but cannot >be allocated to any other LPAR, hence 'unassigned'. As Jim and I talked, I >recollected a past conversation with a local CE to that effect. The LPAR in my >display recently got 15 GB of storage added to it. The resulting odd value >left 1 GB unassigned.
Well this was my first tought when I saw the stroage assigned was an odd number of GBs: Maybe the hardware assignes storage in 2GB increments. This would explain the 1GB uassigned to align to the next 2GB boundary. I usually try to verify before posting, so I looked at the z13 Technical Guide redbook and found the table below (only parially coied here). I read there that an LPAR having less than 256GB of mainstorage (yours) will have a granularity of 512MB. Well, I thougth, wrong trace, and did not post. After your post, either I misinterpret the table in the redbook (most probably) or the table is in error (not likely). So the table must indicate the minimum amount of storage that can be varied online or offline depending on the total amount of storage assigned. True? Table 3-7 Logical partition main storage granularity Logical partition: Largest main storage amount.............Main storage granularity -----------------------------------..............-------------------------------- Main storage amount <= 256 GB ..........................................512 MB 256 GB < main storage amount <= 512 GB ..........................................1 GB 512 GB < main storage amount <= 1 TB ................................................2 GB -- Peter Hunkeler ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
